Adiabatic Data Center Cooling

Indirect free cooling in combination with adiabatic humidification – this is the principle of the Adia-DENCO® cooling system. This system, which has been especially developed for data centers, is based on the design of the well-proven CAIR air-handling units. It offers rated air flows up to 55,000 m³/h and cooling duties over 300 kW. The design is flexible and tailored to your application. The extremely low annual operating costs of the Adia-DENCO® cooling system enable its amortization after a short period.




At outdoor temperatures under 6 °C, the indirect free cooling alone of the Adia-DENCO® is sufficient to completely extract the thermal load produced. At this operating point, all additional cooling sources (adiabatic sources as well as compression-refrigeration cooling) are switched off. The highly efficient EC fans in the outside-air flow operate at their minimum speed and assure that the temperature of the supply air for the computer center does not exceed 25 °C. At outdoor temperatures between 6 and 22 °C, it suffices to control only the EC fans steplessly up to their maximum speed level. It is only at temperatures above 22 °C that adiabatic cooling is required. The integrated open- and closed-loop control system finds the energetic minimum here between the fan output and the required adiabatic cooling. Depending on the output demand from the computer center and at outdoor temperatures over 29 °C, the adiabatic cooling system is supported by an additional peak-load cooler. It can as option be designed for 100 % cooling duty for purposes of redundancy.

The adiabatic cooling system is based on the simple principle that evaporating water removes heat from its surroundings. With the Adia-DENCO®, cooling takes place energy-efficiently in a large double-plate heat exchanger. The warm outdoor air is first humidified, which cools it, and is then sent to the recuperator. This dual recuperator then cools the entering warm return air from the computer center by hermetically sealed heat exchange. The large surface involved here enables highly efficient operation at all operating points, with low pressure drop.

As a result of its performance profile, the new Adia-DENCO® cooling system satisfies the new environmental recommendations for computer centers, which advise maximum supply-air temperatures of 27 °C. The very low number of annual hours with outside temperatures above 29 °C (in moderate climates) reduces the annual energy requirements for compression refrigeration to an absolute minimum – or renders it entirely unnecessary. As a result of this extensive reduction of the compression refrigeration required, operators of computer centers can save up to 70 % of required energy and correspondingly reduce their operating costs. And this applies in all moderate to cold climate regions of the world.

Neem contact met ons op

FläktGroup Netherlands B.V.

Rivium Oostlaan 11
2909 LL Capelle aan den IJssel
+31 10 235 06 06
+31 10 235 06 07

  • PUE < 1.05 possible
  • Highest energy efficiency (EER) according to legislation, market trend and latest component technology
  • Lowest operating cost
  • Comprehensive after-sales service (for operators)
  • Innovative cooling for ICT market
  • Exploits the principle of free cooling in combination with adiabatic humidification
  • No need of compressor cooling
  • Design based on well-proven CAIR air handling units
  • Various sizes up to 300 kW cooling duty and more
  • Flexible application tailored design
  • EC plug fanwall
  • New large double plate heat exchanger (Al/epoxy)
  • Additional optional cooler for peak loads or full redundancy (chilled water or evaporator)
  • Outdoor installation as an option
  • © 2017 DencoHappel. All rights reserved.